Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
13
8
show 802.1x auth_configuration
Purpose To display the current configuration of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_configuration {ports <portlist>}
Description The show 802.1x auth_configuration command displays the
current configuration of the 802.1x Port-based Network Access
Control server application on the Switch.
The following details are displayed:
802.1x: Enabled/Disabled − Shows the current status of 802.1x
functions on the Switch.
Authentication Mode: Port-based/Mac-based/None − Shows the
802.1x authorization mode.
Authentication Method: Remote/none − Shows the type of
authentication protocol suite in use between the Switch and a
RADIUS server.
Port number − Shows the physical port number on the Switch.
AdminCrlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCrlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto − Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request/Identity packets.
SuppTimeout − Shows the time to wait for a response from a
supplicant (user) for all EAP packets, except for the Request/Identity
packets.
ServerTimeout − Shows the length of time to wait for a response
from a RADIUS server.
MaxReq − Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthPeriod − Shows the time interval between successive
reauthentications.
ReAuthenticate: true/false − Shows whether or not to reauthenticate.
Parameters ports <portlist> − Specifies a port or range of ports to be viewed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To display the 802.1x configurations:
DGS3100# show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Method : None