Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
19
7
32
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable lldp (global)
disable lldp
enable lldp
forward_message
disable lldp
forward_message
config lldp
message_tx_interval
<sec 5 - 32768 >
config lldp
message_tx_hold_multiplier
< 2 - 10 >
config lldp reinit_delay < sec 1 - 10 >
config lldp tx_delay < sec 1 - 8192 >
show lldp ports <portlist>
show lldp ports ports [<portlist>]
show lldp local_ports ports [<portlist>] [mode{brief | normal | detailed}]
show lldp remote_ports ports [<portlist>] [mode{brief | normal | detailed}]
config lldp ports [<portlist> | all] notification [enable | disable]
config lldp ports [<portlist> | all] admin_status [tx | rx | both | disable]
config lldp ports [<portlist>|all] mgt_addr [enable | disable]
config lldp
ports [<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp
ports [<portlist>|all] dot3_tlvs mac_phy_configuration_status [enable |
disable]
Each command is listed in detail, as follows:
enable lldp (global)
Purpose To enable LLDP on the switch.
Syntax
enable lldp
Description The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
Parameters None