Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
16
1
25
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
create arpentry <ipaddr> <macaddr>
config arpentry <ipaddr> <macaddr>
delete arpentry [<ipaddr> | all]
show arpentry {ipif system | ipaddress <ipaddr> | static }
config arp_aging time <value 1-65535 >
clear arptable
config
arp_spoofing_prevention
[add gateway_ip <ipaddr> gateway_mac <macaddr> ports [<portlist>|all] |
delete gateway_ip <ipaddr>]
show
arp_spoofing_prevention
Each command is listed in detail, as follows:
create arpentry
Purpose To insert a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description The create arpentry command enters an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS3100# create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS3100#
config arpentry
Purpose To configure a static entry in the ARP table.