Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
15
7
expressed numerically.
<hh:mm> - The time of day to begin DST in hours and
minutes, expressed using a 24-hour clock.
<week 1-4,last> - The week of the month in which DST
ends, where 1 is the first week, 2 is the second week and
so on, and last is the last week of the month.
<day sun-sat> - The weekday on which DST ends,
expressed using a three character abbreviation (sun, mon,
tue, wed, thu, fri, sat)
<month 1-12> - The month of the year to end DST,
expressed numerically.
<hh:mm> - The time of day to end DST, in hours and
minutes, expressed using a 24-hour clock.
annual - Enables DST seasonal time adjustment on an annual basis.
Annual mode requires that the DST beginning and ending date be
specified concisely. For example, specify to begin DST on April 3
and end DST on October 14. The format for annual mode is as
follows, and in the order listed:
<date 1-31> - The day of the month to be
gin DST,
expressed numerically.
<m
onth 1-12> - The month of the year to begin DST,
expressed numerically.
<hh:mm> - The time of day to begin DST in hours and
minutes, expressed using a 24-hour clock.
<date 1-31> - The day of the month to en
d DST, expressed
numerically.
<m
onth 1-12> - The month of the year to end DST,
expressed numerically.
<hh:mm> - The time of day to end DST, in hours and
minutes, expressed using a 24-hour clock.
offset [30 | 60 | 90 | 120] - Indicates the number of minutes to add
during the summertime. The possible offset times are 30, 60, 90,
and 120. The default value is 60.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch to run from the 2
nd
Tuesday in April at 3 PM until the 2
nd
Wednesday in
October at 3:30 PM and add 30 minutes at the onset of DST:
DGS3100# config dst repeating 2 tue 4 15:00 2 wed 10 15:30 offset 30
Success.
DGS3100#