Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
13
5
20
802.1X COMMANDS
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable 802.1x
disable 802.1x
config 802.1x <feap> [enable | disable]
show 802.1x
auth_state
{ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802.1x
auth_parameter ports
[<portlist> | all] [default | { port_control [force_unauth | auto | force_auth] |
quiet_period <sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-10> | reauth_period
<sec 300-4294967295> | enable_reauth [enable | disable]}]
config 802.1x init port_based ports [<portlist> | all]
config 802.1x
auth_protocol
[radius | none]
config 802.1x reauth port_based ports [<portlist> | all]
config radius add
<server_ip> ][ key <passwd 128>] [default | {auth_port <udp_port_number 1-
65535> | acct_port <udp_port_number 1-65535>}]
config radius delete <server_ip>
config radius
<server_ip> {| key <passwd 128> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
show radius
config 802.1x
auth_mode
ports <portlist> [port_based | mac_based]
create 802.1x
guest_vlan
<vlan_name 32> state [enable| disable]
delete 802.1x
guest_vlan
config 802.1x
guest_vlan ports
<portlist> state [enable| disable]
config 802.1x radius-
attributes
<portlist> vlan state [enable | disable]
show 802.1x
guest_vlan
Each command is listed in detail, as follows: