Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
13
7
To configure 802.1x feap on the Switch:
DGS3100# config 802.1x feap enable
Success.
DGS3100#
Success.
DGS3100#
show 802.1x auth_state
Purpose To display the current authentication state of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_state {ports <portlist>}
Description The show 802.1x auth_state command displays the current 802.1x
authentication state of the specified ports of the Port-based Network
Access Control server application on the Switch.
The following details are displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating
/ Authenticated / Held / ForceAuth / ForceUnauth − Shows the current
state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success /
Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means that
the user was not authenticated, and cannot access the network.
Parameters ports <portlist> − A port or range of ports whose settings are to be
displayed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To display the 802.1x authentication states (stacking disabled) for Port-based 802.1x:
DGS3100# show 802.1x auth_state ports 1:1-5
Port Auth PAE State Backend State Port Status
-------- ----------------------- --------------------- ----------------
1 forceAuth initialize authorized
2 initialize initialize authorized
3 initialize initialize authorized
4 initialize initialize authorized
5 forceAuth initialize authorized
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All