Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
12
9
19
MLD SNOOPING COMMANDS
The MLD Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable mld_snooping
disable mld_snooping
config mld_snooping
[<vlan_name 32> | all] {host_timeout <sec 60-16711450> | router_timeout <sec
1–16711450> | done_timer <sec 0-16711450> | state [enable | disable]}
config mld_snooping
mrouter_port
<vlan_name 32> [add | delete] <portlist>
config mld_snooping
mrouter_port_forbidden
<vlan_name 32> [add | delete] <portlist>
show mld_snooping {vlan <vlan_name 32>}
show mld_snooping
forwarding
{vlan <vlan_name 32>}
show mld_snooping
group
{vlan <vlan_name 32>}
show mld_snooping
mrouter_port
{vlan <vlan_name 32> | static | dynamic| forbidden }
Each command is listed in detail, as follows:
enable mld_snooping
Purpose To enable MLD snooping on the Switch.
Syntax
enable mld snooping
Description The enable mld snooping command enables MLD snooping on the
Switch.
Parameters None
Restrictions Only administrator or operator–level users can issue this command
Example usage:
To enable the MLD snooping:
DGS3100# enable mld_snooping
Success.
DGS3100#