Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
Command Parameter
disable telnet
enable dhcp_relay
disable dhcp_relay
config dhcp_relay add
ipif
<ipaddr>
config dhcp_relay
delete ipif
<ipaddr>
show dhcp_relay ipif <ipaddr>
show tech-support show tech_support [config | memory]
show environment
config time_range
<range_name 32> [hours start_time <time hh:mm> end_time <time hh:mm>
wee
kdays <daylist> | delete]
show time_range
Config terminal log
[enable | disable]
show cable status <portlist>
Each command is listed in detail, as follows:
create account
Purpose To create user accounts.
Syntax
create account [admin | oper | user] <username 15>{password
<pa
ssword_string> {encrypted}}
Description
The create account command creates an administrator, operator,
or user a
ccount that consists of a username and an optional
password. Up to 31 accounts can be created. You can enter
username and Enter. In this case, the system prompts for the
account’s password, which may be between 0 and 15 characters.
Alternatively, you can enter the username and password on the
same line.
Parameters admin − creates an administrator account.
oper − creates an operator account.
user − creates a user account with read-only permissions.
<username 1-15> − The account username may be between 1 and
15 characters.
password <p
assword_string> {encrypted} - the account password
can be included, and (optionally) can be encrypted.
Restrictions Only Administrator or Operator-level users can issue this command.
NOTE: You are not required to enter a User Name. Howeve
r, if you do not enter a User Name,
you cannot perform the following actions:
Create a monitor or operator (level 1 or level 14) users until an administrator user (level 15) is
defined.
Delete the last administrator user if there are monitor and/or operator users defined.
Example usage:
To create an administrator-level user account with the username ‘dlink’:
12