Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
19
9
disable lldp forward_message
Purpose To disable forwarding of LLDP message on the switch. When LLDP
is disabled.
Syntax
disable lldp forward_message
Description The disable lldp forward message command disables lldp forward
messaging on the switch.
Parameters None
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable LLDP forward message on the switch:
DGS3100# disable lldp forward_message
Success.
DGS3100#
config lldp message_tx_interval
Purpose To define the lldp message tx interval
Syntax
config lldp message_tx_interval <5-32768>
Description The config lldp message_tx_interval defines the lldp message
interval of the incoming messages.
Parameters message_tx_Interval – Defines the message interval time. The
range is between 5 and 32768.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To configure LLDP message tx interval on the switch:
DGS3100# config lldp message_tx_interval 5
Success.
DGS3100#
config lldp message_tx_hold_multiplier
Purpose To define the lldp hold-multiplier on the switch.
Syntax
config lldp message_tx_hold_multiplier <2-10>
Description The config lldp message_tx_hold_multiplier <2-10> command
specifies the amount of time the receiving device should hold a Link
Layer Discovery Protocol (LLDP) packet before discarding it.
Parameters Message_tx_hold_multiplier (2-10) – Specifies the hold time to be
sent in the LLDP update packets as a multiple of the timer value.
(Range: 2-10). The default configuration is 4.