Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
15
3
23
TIME AND SNTP COMMANDS
The Time and SNTP commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameter
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 60-86400>}
show sntp
enable sntp
disable sntp
config time date <date ddmmyyyy> <time hh:mm:ss>
config time_zone
{operator [+ hour <gmt_hour 0-13> minute <minute 0-59> | - hour <gmt_hour 0-
12> minute <minute 0-59>]}
config dst
[disable | repeating {week day month hh:mm week day month hh:mm | offset [30
| 60 | 90 | 120]} | annual {date month hh:mm date month hh:mm | offset [30 | 60
| 90 | 120]}]
show time
Each command is listed in detail, as follows:
config sntp
Purpose To setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-
interval <int 60-86400>}
Description The config sntp command configures SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
Parameters primary <ipaddr> – Specifies the IP address of the primary SNTP
server.
secondary <ipaddr> – Specifies the IP address of the secondary
SNTP server.
poll-interval <int 60-86400> – The interval between requests for
updated SNTP information. The polling interval ranges from 60
seconds (1 minute) to 86,400 seconds (1 day).
Restrictions Only administrator or operate-level users can issue this command.
SNTP service must be enabled for this command to function (enable
sntp).
Example usage:
To configure SNTP settings: