Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
13
0
disable mld_snooping
Purpose To disable MLD snooping on the Switch.
Syntax
disable mld snooping
Description The disable mld snooping command disables MLD snooping on
the Switch.
Parameters None
Restrictions Only administrator or operator-level users can issue this command
Example usage:
To disable the MLD snooping:
DGS3100# disable mld_snooping
Success.
DGS3100#
config mld_snooping
Purpose To configure mld snooping.
Syntax
config mld_snooping [<vlan_name 32> | all] {host_timeout <sec
60-16711450> | router_timeout <sec 1-16711450> | done_timer
<sec 0-16711450> | state [enable | disable]}
Description The config mld_snooping command defines mld snooping on the
VLAN.
Parameters vlan_name 32 – specifies that the mld snooping applies only to this
previously created VLAN.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
host_timeout – Specifies the maximum amount of time a host can be
a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout – Specifies the maximum amount of time a route can
be a member of a multicast group without the Switch receiving a
host membership report done timer. The default is 300 seconds.
done_timer – Specifies the maximum amount of time a host can be
a member of a multicast group after sending a done timer
membership report. The default is 10 seconds.
state – Allows the user to enable or disable MLD snooping for the
specified VLAN.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure mld snooping:
DGS3100# config mld_snooping
Command: config mld_snooping
mrouter_port Config Mld Snooping Router Port
mrouter_port_forbidden Config Mld Snooping Forbidden Router Port