Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
19
5
31
LACP COMMANDS
The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config lacp port_priority <portlist> [priority 1-65535] [timeout <90sec | 3sec>]
show lacp {<portlist>}
Each command is listed in detail, as follows:
config lacp port_priority
Purpose To set the priority value of a physical port in an LACP group.
Syntax
config lacp port_priority <portlist> [priority 1-65535] [timeout
<90sec | 3sec>]
Description The config lacp port_priority command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
Parameters <portlist> - A port or range of ports to be configured.
<priority 1-65535> - Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout> - Specifies the administrative LACP timeout.
90sec – Specifies the LACP timeout to be 90 seconds. This
is the default.
3sec – Specifies the LACP timeout to be 3 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the LACP priority of a port:
DGS3100# config lacp port_priority 1 priority 2
Success.
DGS3100#
show lacp
Purpose To display current LACP port mode settings.
Syntax
show lacp {<portlist>}
Description The show lacp command displays the current LACP mode settings.
Parameters <portlist> - A port or range of ports whose LACP settings are to be
displayed.
If no parameter is specified, the system displays the current LACP