Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
70
15
clock daemon
16 local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)
local0 − Specifies that local use 0 messages are to be sent to the
remote host. This corresponds to number 16 from the list above.
local1 − Specifies that local use 1 messages are to be sent to the
remote host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages are to be sent to the
remote host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages are to be sent to the
remote host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages are to be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages are to be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages are to be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages are to be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that
the syslog protocol is to use to send messages to the remote host.
ipaddress <ipaddr> − Specifies the IP address of the remote host to
which syslog messages are to be sent.
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure a syslog host:
DGS3100# config syslog host all severity all facility local0
Success.
DGS3100#
delete syslog host
Purpose To remove a previously configured syslog host from the Switch.
Syntax
delete syslog host [<index 1-4> | all]
Description The delete syslog host command removes a previously configured
syslog host from the Switch.