Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
20
0
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP Message tx hold multiplier settings:
DGS3100# config lldp message_tx_hold_multiplier 2
Success.
config lldp reinit_delay
Purpose To define the lldp reinint–delay on the switch.
Syntax
config lldp reinit_delay < sec 1 - 10 >
Description The lldp reinit_delay seconds command specifies the minimum
time an LLDP port will wait before reinitializing LLDP transmission.
Parameters sec – Specifies the minimum time in seconds an LLDP port will wait
before reinitializing LLDP transmission. The range is 1 – 10
seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To configure LLDP reinit delay:
DGS3100# config lldp reinit_delay 1
Success.
DGS3100#
config lldp tx_delay
Purpose To configure the lldp tx_delay on the switch.
Syntax
config lldp tx_delay < sec 1 - 8192 >
Description The lldp tx_delay command specifies the delay between
successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
Parameters sec – Specifies the minimum time in seconds an LLDP port will wait
before reinitializing LLDP transmission. The range is 1 – 10
seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP tx delay:
DGS3100# config lldp tx_delay 1
Success.
DGS3100#