Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
20
6
33
STACKING COMMANDS
The Stacking commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config box_id current_box_id <value 1-6> new_box_id [auto | 1 | 2 | 3 | 4 | 5 | 6]
show stack_information
config box_id
Purpose To change the unit ID (stack membership number).
Syntax
config box_id current_box_id <value 1-6> new_box_id [auto | 1 |
2 | 3 | 4 | 5 | 6]
Description The config box_id command changes the unit ID (stack
membership number). The command takes effect only after
rebooting the device.
Parameters current_box_id <value 1-6> - Specifies the unit’s current stack
membership number.
new_box_id <auto | 1 | 2 | 3 | 4 | 5 | 6> - Specifies the units’s new
stack membership number. If auto is specified, the system
automatically defines the unit’s new ID.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To change the unit ID from 1 to 2:
DGS3100# config box_id 1 new_box_id 2
DGS3100#
show stack_information
Purpose To display information about the units in the stack.
Syntax
show stack_information
Description The show stack_information command displays information about
the units in the stack, including the unit numbers, firmware version,
hardware version, Master ID and Backup ID.
Parameters None.
Restrictions None.
Example usage: