Extron electronic MPX PLUS 866 A Switch User Manual


  Open as PDF
of 222
 
Switcher Software, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
5-4
PRELIMINARY
DSP Configurator Program
Starting the program
N
Extron recommends connection via the Ethernet LAN port for the DSP
Configurator program.
To run the DSP Configurator Program, click Start > Programs > Extron Electronics
> DSP Configurator > DSP Configurator. The DSP Configurator program starts in
Emulate mode (figure 5-3, on the next page).
Using the program
In the DSP Configurator window in Emulate mode, you can tailor a variety of audio
parameters and then transfer them to the MPX by going to Live mode (connected to
anMPX).YoucanalsoswitchtoLive mode and then tailor the audio settings in real
time, while listening to the audio output with a critical ear. See “Emulate mode vs.
Live mode”, later in this chapter.
N
There are three possible DSP Configurator displays:
• AudioandvideoI/Opage(gure5-3)
• Audio-onlyI/Opage
• Video-onlyI/Opage
The DSP Configurator program always starts in the audio and video I/O page,
as shown in figure 5-3. Three additional control blocks are availalable in the
video-only I/O page. See “Video-only I/O page controls“, later in this chapter.
 previous next