Filter
Top Products
5-23
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
PRELIMINARY
Emulate mode vs. Live mode
The DSP Configurator program always starts in Emulate mode. In Emulate mode,
you can perform all of the functions available in the DSP Configurator program,
without connecting a switcher to the computer, and save all of the ties and
settings to a configuration file on your PC. When you open the file via the DSP
Configurator program, the program restores all ties and settings as the current
configuration (emulated if in Emulate mode or live, in the switcher, if in Live mode)
and makes presets saved in the file available for recall.
Synchronizing: pull vs. push
When you switch to Live mode, after making ties or setting processors in Emulate
mode, you need to synchronize the switcher and the DSP Configurator program.
Youaregiventheopportunitytoeither:
• Pull data from the switcher and update the DSP Configurator program’s
configuration
• Push data from the DSP Configurator program to the switcher, overwriting ties,
settings, and presets in the switcher
YoucanalsoswitchtoLive mode and then tailor the audio settings in real time,
while listening to the audio output with a critical ear.
Selecting Live mode and pulling data
Switch from Emulate mode to Live mode as follows:
N
Extron recommends connection via the Ethernet LAN port for DSP Configurator.
1. Click the Mode Live button (figure 5-17). The Communication Type Selection
windows appears, with either the TCP/IP tab or RS-232 tab active.
1
2
3a
3b
3c
4a
4b
4c
2
or
Figure 5-17 — Selecting Live mode
2
. If necessary and as desired, click either the:
•
TCP/IPtab (for connection via the LAN port (preferred) — proceed to
step 3), or
• RS-232 tab (for connection via either of the rear panel RS-232 ports or the
front panel Configuration port — proceed to step 4).