Filter
Top Products
Switcher Software, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
5-24
PRELIMINARY
3. IfyouselectedTCP/IPinstep2:
a
. Observe the IP Address field in the IP Connection window. The field
displays the last IP address entered.
IftheIPAddresseldiscorrect, proceed to step 3b.
If the address is not correct, either click in the IP Address field and
enter the IP address or click on the scroll down button ( ) to open a
drop-down list and select from among the recently used addresses.
Proceed to step 3b.
N
If the local system administrators have not changed the value, the factory-
specified default, 192.168.254.254, is the correct value for this field.
b
. If the switcher is password protected, click in the Password field and
enter the appropriate administrator password.
c
. Click Ok.
The Synchronize with Device dialog box (figure 5-18, on page 5-25) appears.
Proceed to step 5.
4
. If you selected RS-232 in step 2:
a
. Click the Com Port drop-down menu and select the PC’s comm port
that is connected to the switcher’s front panel Configuration port or rear
panel RS-232 port.
b
. Check the baud rate displayed in the comm port selection
window. If you need to change the baud rate to match
the switcher’s rate, click the Baud Rate drop-down menu
and select the desired baud rate. The default is 9600.
c.
Click Ok.
The Synchronize with Device dialog box appears. Proceed to step 5.
5
. If necessary and as desired, click (figure 5-18) either the:
• Pull radio button (to configure the DSP Configurator program to match
the switcher — proceed to step 7)
• Push radio button (to configure the switcher to match the DSP
Configurator program — proceed to step 6)
N
Extron recommends performing a design rule verification before pushing to
ensure that the DSP is not overloaded. See “DSP capacity and design rule
verification“, on page 5-30.