Extron electronic MPX PLUS 866 A Switch User Manual


  Open as PDF
of 222
 
4-13
MPX Plus 866 A Media Presentation Matrix Switcher • SIS Programming and Control
PRELIMINARY
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Save, directly write, name, and recall presets
N
•Iftheusertriestorecallapresetthatisnotsaved,thematrixswitcherrespondswiththeerrorcodeE11.
•
The following characters are invalid in preset names: + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
Save the current
configuration as a global
ties preset
X1)
, Spr
X1)]
Command character is a
comma.
Example:
9,
Spr09
]
Save current ties as preset 9.
Direct write process —
N
The direct write of a global ties preset command should always be preceded by a clear global ties preset command
of that same preset number, as shown below. In a directly-written preset, each output position’s tied input (or no tied
output) remains unchanged unless overwritten or cleared.
If you do not clear a global ties preset number before you directly write a global ties preset to that number, ties that are
part of the previous version of the specified preset can unexpectedly become part of the newly-created preset.
Clear a global ties preset
E
+
X1)
P0*!
}
Spr
X1)]
Clear all ties in preset
X1)
.
Directly write a global
ties preset
E
+
X1)
P
X!
*
X@
!
X!
*
X@
%
X!
*
X@
$ ...
X!
*
X@
&
}
Enter as many ties as are
valid for this model. The
tie all (!
),tieRGBHV(&), tie
video (%), and tie audio ($)
commands are all valid.
Spr
X1)]
Example:
E
+27P0*!
}
Spr27
]
E+27P2*5!10*2$13*11%3*6&
Brackets are shown to
separate ties for clarity only.
Create global ties preset 27,
which ties video and audio
input 2 to output 5,
audio input 10 to output 2,
video input 13 to output 11,
and video input 3 to output 6.
Spr27
]
Recall a global or partial
preset
X1)
. Rpr
X1)]
Command character is a
period.
Example:
5.
Rpr
X1)]
Recall preset 5, which
becomes the current
configuration.
Write preset name
EX1)
,
X1!
NG
}
Nmg
X1)
,
X1!]
Example:
E
1,Security1NG
}
Nmg01,Security 1
]
Name preset 1 “Security 1”.
Read preset name
EX1)
NG
} X1!]
Example:
E
2NG
}
Security 2
]
Command/response table for basic SIS commands (continued)
N
X!
= Input number 00 – 14 (00 = untied)
X@
= Output number 01 – 12 for video
01 – 06 for audio
X1)
= Preset # 32 maximum (0 = current configuration)
X1!
= Name 12 characters maximum
 previous next