Extron electronic MPX PLUS 866 A Switch User Manual


  Open as PDF
of 222
 
3-49
MPX Plus 866 A Media Presentation Matrix Switcher • Operation
PRELIMINARY
Performing a hard reset (reset 1)
The hard reset function restores the switcher to the base firmware that it was
shipped with. After a hard reset, events do not automatically start, but user settings
and files are restored. Perform a hard reset as follows:
N
The hard reset restores the factory-installed firmware. The switcher reverts to
that factory firmware the next time power is cycled off and on unless a firmware
update is performed before the power cycle.
1
. If necessary, turn off power to the switcher.
2. Press and hold the Reset button on the rear panel while you apply AC power
to the switcher.
Power
RESET
LAN
CT
LINK
RESET
LAN
CT
LINK
Press and hold the Reset button while you apply power to the switcher.
The switcher flashes the front panel
buttons and then turns them off.
Continue to hold the Reset button until all input and output buttons return
to unlit and the Video and Audio buttons light.
Release the Reset button.
Optimizing the Audio
N
Thissectionaddressesonly the frontpanelcontrolsforoptimizingvideo.For
settingthedigitalsignalprocessoradjustments,see“OptimizingtheAudio”in
chapter 5, “Switcher Software”.
Each individual input audio level can be adjusted within a range of -18 dB to
+24 dB, so there are no noticeable volume differences between sources and for the
best headroom and signal-to-noise ratio. Adjust the audio gain and attenuation as
follows:
1
. Connect audio sources to all desired inputs and connect the audio outputs
to output devices such as audio players. See “Audio input and output
connections”, in chapter 2, “Installation”. For best results, wire all of the
inputs and the outputs balanced.
2
. Power on the audio sources, the switcher, and the audio players.
3. Switch among the inputs (see “Creating a configuration”, in this chapter),
listening to the audio with a critical ear or measuring the output audio level
with test equipment, such as a VU meter.
4
. As necessary, adjust the input audio level of each input (see “Viewing and
adjusting the input audio level”, in this chapter) so that the approximate
output level is the same for all selected inputs.
5
. As necessary, adjust the output audio level of each output (see “Viewing and
adjusting the output volume”, in this chapter).
 previous next