Filter
Top Products
Operation, cont’d
MPX Plus 866 A Media Presentation Matrix Switcher • Operation
3-24
PRELIMINARY
Example 6: Setting the RGB delay for an output
Inthefollowingexample,theRGBdelayisincreasedfortiestooutput1.Thesteps
show the front panel indications that result from your action.
1
. Clear all selections: Press and release the Esc button.
C O N T R O L
PRESET
ENTER
ESCVIEW
Press and release the Esc button.
The button flashes once.
2. Select Video mode: Press and hold the Video button for approximately 2
seconds.
VIDEO VIDEO
Press and hold the Video
button until it blinks.
Release the button.
2 seconds
3. Select an input: Press and release the output 1 button.
N
An output from the low resolution video group cannot be selected.
COMPUTER INPUTS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1
2
3
4
VIDEO INPUTS
COMPUTER/AUDIO O
Press and release the
Output 1 button.
The button lights green.
The input buttons 1 through 10 display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5 seconds of RGB delay.
3.53.02.52.01.51.00.5
N
The RGB delay is protected when front panel lock mode 2 is selected. You
can view the delay in lock mode 2, but not change it from the front panel. See
“Setting the front panel Locks (Executive modes)” on page 3-44.
If front panel lock mode 2 is selected and you try to perform steps 4, the actions
are ignored and the Enter, Video, and Audio buttons flash.