Filter
Top Products
113
Chapter 4, Making Measurements
Analog Parameters
Making Measurements
Analog Parameters
Analog parameters are measured in either Connect state or test mode.The
measurement procedure described below is for the Connect mode. To measure in
the test mode, select the
ANLG MEAS screen.
You can measure parameters of a TIA/EIA-136 mobile on its Analog Voice
Channel (AVC). For measurements on this analog channel, use the following
procedure.
The Test Set must be active on an AVC. If your mobile is active on a DTC, you
must first either Originate, Page, or Handoff to an AVC.
1. Make sure the Test Set is in Connect state on an AVC. See “Registration” on page 93.
2. Select
Meas
from the
Data/Meas
field.
3. The analog measurements should be displayed.
Figure 36 Analog Measurements Display
Scrn27.tif