Filter
Top Products
33
Chapter 1, Getting Started
Get ready to test
Getting Started
Get ready to test
Described In this
Chapter
Refer to the following flowchart to see the steps necessary to get the Test System
ready to test a mobile.
Select CALL CNTL to return to
the primary call processing screen.
Select ZERO to zero the Average
Select CALL CNFG to display
the screen with the Power Meter
Select DCCH to activate
the TIA/EIA-136 screens.
Select CALL CNTL from the
To Screen to go to the call
YES
NO
Connect the mobile to the Test Set.
processing screen.
Zero command.
Power measurement.
Make sure the Cellular Adapter, and PCS Interface (if used), and the Test Set are properly connected. If the PCS
Interface is used, the HP 83236B System Connectivity test must be successfully completed before proceeding.
Turn on the PCS Interface (if used), then turn on the Test Set. See
“important: turning on the pcs interface” on page 43.
Set the Notch Filter to track
the audio frequency
generator (AFGen1).
Audio
Testing?
Using
PCS
Interface?
No
Yes
Perform the PCS Interface preparation
steps described in
“Using the PCS
Interface” on page 44
.
Test
Set has
Option 006?
Yes
No