Filter
Top Products
247
Chapter 8, Connector Descriptions
Rear Panel Connectors
Connector Descriptions
Rear Panel Connectors
Anl Trig Out This connector outputs the signal used to synchronize external equipment to the
Digital Analyzer. A rising edge indicates the Analyzer was triggered. (Not in use
at this time)
Operating Considerations
All values are rounded to the nearest full bit.
Bit Clk Out This signal outputs a square wave from the Digital Generator’s Bit Clock. This
allows you to synchronize external equipment to the Digital Generator.
Operating Considerations
When using internally generated data, the Gen BB Data Out signal is stable before
the rising edge of the Bit Clk Out, allowing the Bit Clock to be used to strobe the
data into your external equipment.
Output frequency = 48.6 kHz
Output level = CMOS
Output impedance = 50 Ohms
Control I/O This connector provides data communication between the Test Set and the
Cellular Adapter. The Cellular Adapter cannot be turned on without this cable
attached to an operating Test Set.