Filter
Top Products
74
S:\HP83206A\USRGUIDE\MANUAL\cpmeas.fm
Chapter 3, Processing Calls
Authentication
Page a Mobile Station with Authentication
Paging A Mobile Station That Has Registered With The Test Set
1. Register the mobile with the Test System. See
“Initialize Call Processing with
Authentication through Registration” on page 72
2. Select the Page field. The Page annunciator lights while the Test Set pages the mobile
on the forward control channel. The mobile station should ring.
3. Press the SEND key on the mobile station. The Connect annunciator lights if the
mobile station properly signals the Test Set. The mobile station is now connected to the
Test Set on the assigned voice channel. The Traffic Chan Assignment fields is
updated, that is, any “-” in the left-hand fields are replaced with appropriate
information. If page with authentication was successful, “Page w/Auth successful” is
displayed in the last line of information in the upper part of the CALL CONTROL
screen. If page with authentication failed, then “Page w/Auth failed” is displayed.
Originate a Call with Authentication
1. Register the mobile with the Test System. See “Initialize Call Processing with
Authentication through Registration” on page 72
2. Dial the desired phone number on the mobile station and press the SEND key on the
mobile station’s handset. The mobile station signals the Test Set on the reverse control
channel with an origination message which includes the dialed phone number, the
mobile station’s MIN number and the mobile station’s ESN.
If the mobile station transmitted properly on the reverse control channel, the mobile
station’s phone number, ESN, decoded SCM, protocol version, and called phone num-
ber are displayed. The Test Set then reconfigures itself to the traffic channel assign-
ments set up in the
Traffic Chan Assignment
section of the CALL
CONTROL screen. The
Access
annunciator is lit while the Test Set signals the
mobile station on the assigned voice channel. The
Connect
annunciator lights if the
mobile station properly signals the Test Set on the reverse voice channel.
The mobile station is now connected to the Test Set on the assigned voice channel. The
Traffic Chan Assignment
fields are replaced with appropriate information. If
origination with authentication was successful, then “
Origination w/Auth
successful
” is displayed with the other returned mobile information in the upper
portion of the CALL CONTROL screen. If origination with authentication failed, then
“
Origination w/Auth failed
” is displayed.