Filter
Top Products
130
S:\HP83206A\USRGUIDE\MANUAL\meas.fm
Chapter 4, Making Measurements
Power Measurements
Power Measurements
Transmitter power is measured when the Test Set is in the Connect state (the
Connect annunciator is “lit” on the CALL CONTROL screen), or when the when
the mobile is in its Test mode. Test Mode power measurements cannot be made on
the CALL CONTROL screen, but can be made on the DIGITAL
MEASUREMENTS, ANALOG MEAS, DUPLEX TEST, and RF ANALYZER
screens.
The mobile’s transmitted RF power can be measured and displayed several
ways.The power measurement type and method you use depends on several
factors, including:
• The presence of a PCS Interface in your Test System.
• The presence of Option 006 in your Test Set.
• The level of the signal you are measuring.
• The availability of a “reference” signal: an RF carrier at a known signal level, and at the
same frequency of the signal to be measured.
• The type of voice or traffic channel you are measuring: DTC or AVC