Filter
Top Products
288
S:\HP83206A\USRGUIDE\MANUAL\adptinst.fm
Chapter 11, Installing the Cellular Adapter
PCS Interface Connections
PCS Interface Connections
The PCS Interface is used with the Cellular Adapter and Test Set to test US PCS
mobiles (1700 MHz to 1900 MHz). You can also test cellular band (850 MHz)
mobiles through the interface. The interface is controlled entirely through a serial
cable connection to the Test Set.
The PCS Interface is shipped with all cables needed to connect it to the Test Set.
Also shipped with the interface is a memory card containing a System
Connectivity program to verify all connections. This software should be loaded
and run before using the interface.
The following diagrams are for reference only, and do not show all of the rear-
panel connections between the Test Set and the Cellular Adapter (see Figure 78 on
page 286). Complete instructions for connecting the PCS Interface to the Test Set
and running the System Connectivity software are included in the PCS Interface’s
Operating Manual (HP P/N 83236-90100).
Figure 79 PCS Interface Connections
REF IN
10 MHz REF
OUTPUT
ANT INDUPLEX OUT
To ANT IN
To DUPLEX OUT
REF IN
BNC Tee
HP-IB/Ser
10
A0 (LSB)
.
.
.
A5 (MSB)
The HP-IB/Ser switch must be set to Ser.
Serial Port Connections