Filter
Top Products
233
Chapter 7, Screen and Field Descriptions
Parameters of the ANALOG MEASUREMENT Screen
Screen and Field Descriptions
Parameters of the ANALOG MEASUREMENT Screen
This screen is used to make RF and audio measurements on the mobile station
connected to the simulated base station while on an active voice channel.
The host firmware does not monitor the mobile station’s transmitted carrier power
while the ANALOG MEASUREMENT screen is displayed. If the power falls
below 0.0005 Watts no error message is displayed nor will the simulated base
station terminate the call while on the ANALOG MEASUREMENT screen.
The ANALOG
MEASUREMENT
Screen
Figure 73 The ANALOG MEASUREMENT Screen (when DAMPS system type is selected)
AF Anl In Settings: FM Demod, AM Demod, SSB Demod, Audio In, Radio In, Ext Mod,
Mic Mod, FM Mod, AM Mod, Audio Out
Units: None.
This field selects the input for the Audio Frequency analyzer.
scrn28.tif