Filter
Top Products
Contents
26
9 Troubleshooting
General Operating Reminders 254
254
Remote Operation Considerations and Recommendations 257
Loopback BER 257
To Prevent Problems When Changing the System Type 257
Temperature Compensation 257
Handoffs 257
Releasing a Call 257
Going from the Data Display to the Measurement Display Mode 257
Changing from ANALOG MEAS Screen to CALL CONTROL Screen
Measurements 258
Zeroing the Power Meter With a PCS Interface 258
Triggering to Prevent Non-recoverable Firmware Errors 258
Reducing Wait Statements in Your Program 258
Problems With or Without a PCS Interface Present 259
Mobile will not camp on a Control Channel. 259
Message “DTC msg not acknowledged by mobile” occurs during attempt to page
mobile. 259
Mobile successfully answers page but immediately drops the call. 259
The message “Squelch Interrupt Overfull. Press MEAS RESET” is
displayed. 259
The message “Symbol clock is weak: accuracy is degraded” is displayed. 260
Problems Specific to Using a PCS Interface 261
Mobile will not camp on a Control Channel. 261
Message “Selection not supported in PCS mode” occurs. 261
The PCS Interface is on but the PCS Mode field does not appear on the CONFIG-
URE screen. 261
Messages 262