Filter
Top Products
45
Chapter 1, Getting Started
About the PCS Interface
Getting Started
Figure 8 Setting the PCS Mode control and entering PCS Interface path losses.
Selecting RF OUT Only as the RF Output Port
When the PCS mode is selected, the RF output of the PCS Interface can be
directed to the RF OUT Only port on the PCS Interface. (The RF input to the PCS
Interface always goes to the RF IN/OUT port.)
To select the RF OUT Only port as the RF output:
1. Access the CONFIGURE screen.
2. Set the
PCS Mode
field to
On
.
3. Set the
PCS Source
field to
OUT
.
When
OUT
is selected, the
RF Level Offset
field’s setting is not applied to the
output level.
These fields allow you to enter and enable or disable compensation for any
path loss between the mobile and the PCS Interface’s RF IN/OUT port.
This field tells the Test Set to alter its
operation for controlling the PCS Interface.
CNFG_SCRN.pcx