Filter
Top Products
210
S:\HP83206A\USRGUIDE\MANUAL\ref.fm
Chapter 7, Screen and Field Descriptions
Parameters of the CALL CONTROL Screen
Amplitude Settings: -137.0 through +18.0
Units: dBm.
The amplitude of the RF signal that the Test Set will transmit.
Note that the available setting is greater than both the specified maximum output
power of the Test System and the system specification as well. This is done to
allow you to use the maximum output power of each individual Test Set.
Band Settings: Cellular or US PCS
Units: None
The channel band assignment of the traffic channel.
CC Order Settings: SSD Upd, Uniq Ch, Send MWI, Send SMS
Units: None
This field is only displayed when Authentication is turned on, and with the mobile
not in the connect state. It allows you to send a shared secret data update, unique
challenge, message waiting indicator, or short message services command to the
mobile.
See also, “Which Control Order Command Should I Use?” in the HP 8920B
Option 801 Condensed Programming Reference.
Chan Settings: 1through 799, 990 through 1023 (Cellular); 1 through 1999 (US PCS)
Units: None, Integer values.
The channel number of the voice or traffic channel.
Connect Settings: On or Off
Units: None.
Connect is an annunciator. It indicates that the Test Set and the mobile are in
Connect state (a call is up).