Filter
Top Products
148
S:\HP83206A\USRGUIDE\MANUAL\prog.fm
Chapter 5, Programming the Cellular Adapter
Programming the Cellular Adapter
Programming the Cellular Adapter
This Cellular Adapter cannot be used without a Test Set. Programming the Test
Set is described in the HP 8920B Test Set’s Programmer’s Guide Use the Test
Set’s programming information, along with information here and in Chapter 6,
“HP-IB Syntax Diagrams,” on page 169 to program the functions you need for
DAMPS and DCCH.
In order to program many of the analog measurements, you will need to refer to
the HP 8920B Test Set’s Programmer’s Guide.
Programming in
the Call Processing
Subsystem
Any time you access the Call Control screen and its supported screens you are
operating in the Call Processing Subsystem. Remote operation in this subsystem
requires certain programming structures to help eliminate operating errors.
For example, it is very important to use the subsystem’s status registers to monitor
the call status annunciators to control program flow. Failure to use correct
programming procedures could result in instrument lockup.
Therefore, it is important that you read and understand the information in the HP
8920B Test Set’s Programmer’s Guide entitled “Programming the Call Processing
Subsystem”.