Filter
Top Products
91
Chapter 3, Processing Calls
Page
Processing Calls
Page
See “Program Example” on page 149 for an example of the program command.
1. Verify that you have already done the following (refer to “Configure the Test Set to
Emulate a Base Station” on page 64
):
• Zeroed the RF Power meter
• Put the Test Set in Active state
• Connected the mobile to the Test Set and turned the mobile’s power on
• Registered the mobile. (See
“Registration” on page 93)
2. If you registered the mobile, the Mobile Station ID (phone number) of the mobile
appears in the
MS ID
field. Otherwise, you must enter this number.
3. Select
Page
from the list on the left side of the screen.
4. If the mobile responds, you will see the Access annunciator light briefly.
5. Press SEND on the mobile to start the conversation.
6. The Connect annunciator lights. This is the Connect state. Data to be displayed is shown
below.
Figure 23 CALL CONTROL Screen in Connect State
While the mobile
is being paged,
this annunciator
is lit.
When the mobile’s
send button has
this annunciator
is lit.
been pressed,
Con-mode.tif