Filter
Top Products
5-23
Printing Environment Settings
5
SETUP Menu Settings
LAYOUT MENU Options
COPIES
1 to 9999; 1*
Specifies the number of copies to be printed.
The printer prints the specified number of copies.
OFFSET Y/OFFSET X
-50.0 to 50.0; 0.0* (mm)
Adjusts the printing position in the vertical direction (Y) or the horizontal direction
(X) by the specified value.
The printing position changes as follows according to the increase and decrease
of the specified value.
OFFSET Y: As the value increases, the gutter width in the Y direction
increases.
As the value decreases, the gutter width in the Y direction
decreases.
OFFSET X: As the value increases, the gutter width in the X direction
increases.
As the value decreases, the gutter width in the X direction
decreases.
IMPORTANT
If any part of the print image lies outside the printable area after adjusting the
printing position, the part will be missing in the print result.
NOTE
Each time you press [ ], the value increases in 0.5 mm increments, and each
time you press [ ], the value decreases in 0.5 mm increments. If you keep
holding down [ ] or [ ], the speed of the value changing is increased.
Y
X
DEFABC
ABC
Range adjusted by "OFFSET X"
Front Back Front
+ direction
Back
Y
X
DEF
Range adjusted
by "OFFSET Y"
Adjust using
OFFSET X
and OFFSET Y
+ direction
Original margin