Filter
Top Products
5-25
Printing Environment Settings
5
SETUP Menu Settings
GUTTER
-50.0 to 50.0; 0.0* (mm)
Specifies the gutter width for printing with the binding location created. A gutter is
created with the image shifted by the specified value. You can shift the image in
the "+" direction with a positive value and in the "–" direction with a negative value.
Specify on which edge of the paper, the long edge or short edge, the gutter is to
be created in BIND.LOCATION (See the previous item). On which edge (top/
bottom/left/right) of the paper the gutter is created depends on the setting for
BIND.LOCATION and which value "+" or "-" is specified for this item.
IMPORTANT
If any part of the print image lies outside the printable area after creating a gutter,
the part will be missing in the print result.
NOTE
•
Each time you press [ ], the value increases in 0.5 mm increments, and each
time you press [ ], the value decreases in 0.5 mm increments. If you keep
holding down [ ] or [ ], the speed of the value changing is increased.
•
If the settings for OFFSET Y and OFFSET X are specified at the same time as the
setting for this item is specified, the settings for OFFSET Y and OFFSET X are
processed first, and then the setting for this item is processed.
+ direction
- direction[0 mm]
Gutter
Center Center Center
Gutter