Filter
Top Products
7-22
Message List
Troubleshooting
7
Message List
When the printer cannot continue printing for some reason (an error status), the
printer beeps, the Message indicator comes on, and an error message that
indicates the description of the error appears in the display. A Warning message
appears in the display when the printer requires some remedy (a warning status)
although the job is not affected.
If either of these messages appears, perform the following procedures according to
the message.
NOTE
•
When multiple warnings are occurring at the same time, the Waning messages appear
by rotation.
•
When the printer is in error status and warning status at the same time, the Waning
message does not appear.
•
If WARNING STEP in the SETUP menu is set to OFF, a message with (Warning
Message) does not appear even when the printer is in a warning status.
•
For a message with the <Error Skip> mark, you can skip the error by pressing [Online]
and continue printing. However, part of the print data may be missing or it may not be
printed properly. When you want to stop the process, perform a soft reset to eliminate the
cause of the error, press [Online], and then print again. Also, you can automatically skip
the errors to which this mark is attached by setting AUTO ERROR SKIP in the SETUP
menu to ON.
<E nnn-nnnn> ("n" represents a number)
Cause A problem has occurred inside the printer.
Remedy Solve the problem following the instructions in "Service Call Display" (See p.
7-34).
<02 COOLING>
Cause 1 The temperature of the fixing unit exceeded a fixed value after printing
(especially paper with a narrower width) continuously.
Remedy Please wait a moment. The printer cools down the fixing unit automatically. It
resumes the job after finishing the cool down process.