Filter
Top Products
7-32
Troubleshooting
7
Message List
<F2 NO FONT> <Error Skip>
Cause The registered fonts used for creating overlay forms had been deleted during
printing.
Remedy 1 The printer continues printing by pressing [Online]. However, unregistered fonts
are not printed.
Remedy 2 Register the fonts in the memory again or create a form using usable registered
fonts, and then print again.
<F9-nn PWR OFF>ON> ("nn" represents two-digit alphanumeric characters)
Cause A problem has occurred while the printer is processing print data.
Remedy Cycle the power of the printer. If the message appears even after cycling the
power of the printer, note down the message in the display, and contact your
local authorized Canon dealer.
<FF FONT FULL> <Error Skip>
Cause Because of too many fonts to be registered, the field (font table) for registering
font information has run out and overflowed.
Remedy The printer continues printing by pressing [Online]. However, the page with
which an error has occurred is not printed properly.
<FM SIZE ERROR> <Error Skip>
Cause There is some font with its size exceeds the pseudo-scalable font size.
Remedy Perform "Error Skip", then continue printing. However, the characters with which
an error has occurred are not printed properly.
<FM SCALE ERROR> <Error Skip>
Cause There is a character in which the number of coordinate points on the contour
lines exceeds the limitation of a pseudo-scalable font.
Remedy Perform "Error Skip", then continue printing. However, the characters with which
an error has occurred are not printed properly.