Filter
Top Products
8
Setting up the network card
8-4 Pi4700e
Network Interface Card Chapter 8
8.3 Setting up the network card
Connecting a network cable
1
Make sure that Digital Copier power is turned off.
2
Connect the network cable to the Network Card.
❍
Insert the plug into the 10-100BaseT port on the rear panel of the
network card and press it in until you hear it click securely into
place.
3
Power up the Digital Copier and check for abnormalities.
✎
Important!
Use only Category 5 shielded 10/100BaseT cable.
Configuring the network card
You must first configure the Network Card and your computer before you
can print using the Network Card. The settings you need to make depend
on the configuration of your network environment. sections 4 through 6 of
this chapter describe configurations for the environments listed below.
Follow the configurations procedure for the operating system you are us-
ing.
●
Section 4 - Windows configuration
Network printing in a Windows 95/98/Me/2000/XP/NT environment
●
Section 5 - NetWare configuration
Network printing in a NetWare environment
●
Section 6 - Macintosh configuration
Network printing in a Macintosh environment
Network cable
10/100BaseT port