Filter
Top Products
Setting Up IP Parameters
12
Pi4700e 12-55
Appendix Chapter 12
✎
Note
ARP can be used to assign an IP address only. Other IP parameters
must be set using Telnet or a Web browser. For details, see “12.8 Us-
ing Telnet to Make Settings” (p. 12-61) and PageScope Light for
Pi5501 Operator’s Manual.
There are problems with the ARP command in earlier versions of Win-
dows 95, so the command may not function properly if the ARP entry
is blank. To check for and prevent such problems, enter the following
at the MS-DOS prompt.
arp -a
If the ARP entry is blank, ping another valid device on the network as
shown below.
ping <valid IP address for device other than the Net-
work Card>
Next, perform the above procedure starting from step 2.
You cannot use ARP to assign an IP address if the Network Card has
already been assigned an IP address by ATIP.