Filter
Top Products
Using Telnet to Make Settings
12
Pi4700e 12-63
Appendix Chapter 12
Restore Factory Defaults
Select this menu item to restore the Network Card to its initial factory de-
faults. All of the parameters stored in NVRAM are restored to their initial
factory defaults.
✎
Note
Initial factory default values do not take effect until you finish the Telnet
session or power the Network Card down and then power it up again.
Change Password
Select this menu item to change the password used for Telnet connection
and access to the HTTP server. In response to the
New Password
prompt, type in up to eight characters for the new password and then
press . In response to the
Retype New Password
prompt, input the
new password again for confirmation, and then press .
✎
Note
The password you specify here is used for both Telnet and Web page
access. Changing the password using one type of access (Telnet or a
Web browser) also changes the password for the other type of access.
Exiting Telnet (Exit)
Inputting
E
while at Main Menu after changing settings causes the menu
shown below to appear.
The Configuration Utility
Unit Serial no. 460121 V5.04
Exit
1. Save Changes and Exit
2. Save Changes and Reset
3. Exit Without Saving Changes
Select
1
to save your changes without applying them.
Select
2
to save your changes and reset the Network Card, which applies
the changes.
Select
3
to discard your changes.
Enter
Enter