Filter
Top Products
9
Network Setting
9-8 Pi4700e
Scanner Mode Chapter 9
✎
Important!
You must provide information for the SMTP Server Address and Re-
ply Address when you are using the Send to E-mail function. E-mail
cannot be sent if these settings are left blank.
✎
Note
If you haven’t logged on in Admin mode, “***” appears as the IP ad-
dress in SMTP Server Address and FTP Proxy Server Address.
FTP Proxy Configuration Section
SMTP Server Address Type in the IP address of the SMTP server.
Default Subject for E-mail
Attachment
Type in the default subject when distributing scanner data as
E-mail attachments.
Default Subject for FTP
Notification
Type in the default subject when informing by E-mail the URL
of the FTP site where scan data is left.
Reply Address Type in the mail address for a mail replay showing the error
message when a send error is generated.
SMTP Connection Time-
out
Input the SMTP server connection timeout in seconds. You can
input a value from 1 to 120 seconds.
Default Compression Select the default compression method to be used when dis-
tributing scanned data as direct mail.
FTP Proxy Server Address Type in the IP address of the FTP proxy server.
Remote Port Number of
Proxy
Type in the proxy port number. You can input a value from 1 to
65535.
Apply button Click this button to apply any settings you have input up to this
point.
Clear button Click this button to cancel any settings you have input up to this
point.