Filter
Top Products
12
UNIX Configuration
12-38 Pi4700e
Appendix Chapter 12
9
Enter another printer name or quit setup.
Type:
Q
10
Do you want to start the remote daemon now?
Type:
Y
11
Use a line editor to open the
/etc/printcap
file and replace the
:rp=
en-
try with the appropriate remote queue name. The following shows an
example of how this is done when the remote port is named PORT1.
printer1:\
:lp=:\
(This field is used for specification of the local printer device name.
This field must be left empty.)
:rm=lprpriter:\
(Network Card host name recorded in
/etc/hosts
)
:rp=PORT1:\
(Any remote queue name you want)
:sd=/usr/spool/lpd/printer1:
(Name of spool directory on client)
System V Release 4, Solaris 2.x
You can use lpd/lpr if your system recognizes the LPSYSTEM command
is available. Settings can also be made using admintool if the system sup-
ports it.
LPSYSTEM Installation
✎
Note
The following procedure must be performed from the Bourne Shell.
1
At the prompt, type:
lpsystem -t bsd <Network Card host name recorded in
/etc/hosts>
Some systems require input of the remote host IP address instead of
the remote host name.
2
Type the following command:
lpadmin -p <local printer name> -s <Network Card
host name>!<remote queue name>