Filter
Top Products
148
Chapter 6 Configuration - Log Path
Trailer String
Define an escape sequence to be sent to the printer after each print job. For
example, you may want to send a sequence to add a formfeed so you don't
have to manually press the formfeed button on the printer. You may also want
to tell the printer to reset itself in case you have set a header string which tells
the printer to do something special with the job. You can specify up to three
separate sequences per trailer string. The Ethernet Interface executes them
in order from top to bottom. If specifying fewer than four sequences, be sure
to start at the top leaving undefined fields at the bottom.
The most common sequences are listed on the form:
• PCL Reset - tells the printer to reset itself once the data completes
• End of Transmission (EOT) - tells the printer to force the end of the job
• Formfeed - tells the printer to do a formfeed at the end of the data.
Printer Configuration
Specify a printer configuration number to be loaded before processing the
print job. This ability to associate a printer configurations to a logical printer
model allows you to define up to four unique and independent printer
personalities in a single printer. Using this feature, you effectively have four
different printers in one.
To associate a printer configuration to the currently selected destination
queue, just select the desired printer configuration number from the drop
down list. Once a printer configuration have been associated with a
destination queue, any print job sent to that destination queue name will
cause the printer to load the associated printer configuration before
processing the print job.
Configuration - Log Path
Name
Name of the log path. The default names are l1, l2, l3, l4, l5, l6, l7, and l8.
Logpath Type
Define what type of log information will be tracked for each print job passing
through the associated destination. The types are:
• job - job ID, username, etc.
• user - user ID and three messages per job about the start and finish
• checksum - value used when troubleshooting integrity of data transferred
• printer - miscellaneous messages from the printer
• i/o port - status of the printer based on the port interface signals.