Filter
Top Products
252
Chapter 13 Complete Command List
set sysinfo logport null|syslog
set sysinfo logport null
Define where the debugging information should be sent to. This can be
sent to an output device off of the NIC I/O port or to a central TCP/IP host
running a SYSLOG daemon. To set this host, use the command
set
sysinfo syslog hostIPaddress
.
set sysinfo email emailname@IPaddress
set sysinfo email joe@192.75.11.5
Define the user email address to receive printer and job logging
information from a particular logpath on the NIC.
emailname
is the host
or IP name of the user, and
IPaddress
is the IP address where the mail
is stored on your network.
set sysinfo syslog hostIPaddress
set sysinfo syslog 192.75.11.30
Set the IP address of the host running the SYSLOG daemon. NIC
debugging or print job and printer logging information can be sent to that
IP address.
set sysinfo dns DNSserverIPaddress
set sysinfo dns 192.75.11.2
Set your DNS server IP address so the NIC can resolve host names when
used with its built-in Telnet and Ping clients.
set sysinfo descramblekey hexvalue
set sysinfo descramblekey 1234
Set the key value used for descrambling print jobs that have passed
through the npscramble utility on a TCP/IP host. This key is a four-digit
hexadecimal value obtained from the host software, npscramble. Within
the npscramble source code, there is a variable called SR_KEY which
contains the default key value. This can be changed to any four-digit
value you would like.
set sysinfo module [[-]novell] [[-]netbios]
set sysinfo module -novell
Enable and disable certain network protocol stacks within the NIC.
Sometimes it helps to disable any protocols you are not using on your
network.
set time hours [minutes [seconds ]]
set time 10 30
Set the current time noting the
hours
based on the 24-hour system and
the
minutes
and
seconds
ranging from 0 through 59. If the NIC is reset,
this value will be lost so you will need to set the time again.
Note This is not printer or job logging information.