Filter
Top Products
212
Chapter 11 Novell Host Configuration
5. Press INSERT to add a queue.
6. Type in a new queue name and press ENTER.
7. Press ESCAPE.
8. Select “Print Servers.”
9. Press INSERT to add the new print server.
10. Type the name of the NIC. By default, it is
M_xxxxxx where xxxxxx
equals the last six digits of the Ethernet address
(e.g.,
M_000BF5)
11. Select this new print server and press ENTER.
12. Select “Printers.”
13. Press INSERT to add a printer to the list.
14. Type in the name of one of the default destinations on the unit for the
“Name” field and go to the type field.
15. Press ENTER at this field and select “Defined Elsewhere.” If “Defined
Elsewhere” is not available, choose “Parallel.”
16. Press ENTER on the “Print Queues Assigned” field.
17. Press INSERT to display all queues; select the one you defined in step 6.
Then press ENTER.
18. Select a priority and press ENTER. Priority 1 should be sufficient.
19. Press ESCAPE until you are back to Main Menu.
20. Reboot the Print Server by repowering the printer.
21. Check the “Currently Attached Servers” and verify the print server is
active.
22. Press ESCAPE until you are out of the PCONSOLE.
Even though the entire print set up is done through PCONSOLE, you may
want to communicate directly with the print server in order to modify
settings, monitor the unit, etc. To communicate with the print server, the
optional host software, npsh.exe, may be used. npsh.exe is a DOS
executable program that can be run from a DOS prompt on a NetWare
workstation.
npsh.exe performs the following:
npsh nvplist
Lists all of the NIC devices on the network; each name is in the default
format M_xxxxxx (where xxxxxx equals the last six digits of the unit
Ethernet address). This is regardless of whether it is configured as a
PSERVER or an RPRINTER.
npsh unitname
Starts a Telnet-like session with the named print server, allowing you to
configure, monitor, and troubleshoot the unit with the built-in command
set.
npsh unitname command
Initiates a single Command with guest access only to the unit instead of
entering into a complete session.