Filter
Top Products
Set Commands
249
set logpath logpath port TCPportnumber| email|syslog
set logpath l3 port 2000
Determine where the log information should be sent for a print job or
attached printer. The choices are:
TCPportnumber TCP port number ranging from 1024 to 65000.
email Particular user's email address. This address is set
using the
set sysinfo email
emailname@IPaddress
command.
syslog A central TCP/IP host running the SYSLOG daemon.
This host is set using the
set sysinfo syslog
IPaddress
command.
set logpath from default
Set all logpath settings back to factory defaults.
set logpath from stored
Set all current logpath settings to the values stored in flash memory.
set model model name newname
set model m1 name landscape
Change the current name of the
model
to a new name as indicated by
newname
. This
newname
must be nine characters or less or it will be
truncated. These names are case sensitive.
set model model type raw
set model m2 type raw
Set the model
type
to
raw
so that it does not process the data passing
through it in any way.
set model model banner [ps|text|auto [after]]
set model m2 banner text
Determine whether a banner page should be added for print jobs passing
through the
model
mapped destination/queue.
auto
will determine which
type is needed depending on the type of print job data passing through.
By default, banner pages are added to the front of the job. If
after
is set,
the banner page will come at the end.
set model model stty [[-]onlcr] [[-]descramble] [xtab
tablength|none]
set model m3 stty onlcr
Control extra job processing done by the
model
. The processing options
are:
onlcr Carriage return insertion for Unix text jobs. Adds
carriage returns to text jobs with solitary linefeeds.
This will prevent stair-stepped output or output
running off the right side of the page.
descramble Automatic descrambling of print jobs passing through
which have been scrambled using the proprietary
scramble Unix utility, npscramble.
xtab Tab expansion from 1 to 16 spaces.