Filter
Top Products
Section 5: Printer Configuration
M84Pro Service Manual PN 9001111A Page 5-5
Status Select(DSW2-8): For emulating earlier series software commands. Should be used only
if problems are encountered when using existing software. This switch will also affect the settings
selected by DSW1-7 and DSW1-8.
Backfeed Sequence (DSW3-1, DSW3-2): Backfeed is used to correctly position the label for
application and then retract the next label to the proper print position. This operation can be
performed immediately after a label is printed and used, or immediately prior to the printing of the
next label.
Label Sensor Selection (DSW3-3): Enables or disables the Label Sensor. If the Sensor is
enabled, it will detect the edge of the label and position it automatically. If it is disabled, the
positioning must be under software control using Line Feed commands.
DSW2-8 SETTING
Off Status 3 & 4 Enabled
On Status 2 & 3 Enabled
DSW2
ON
OFF
12345678
DSW3-1 SETTING
Off Off Continuous
Off On Tear-Off
On Off Cutter*
On On Dispenser
* Defaults to Continuous if cutter not
installed
DSW3
ON
OFF
12345678
DSW3-3 SETTING
Off Sensor Used
On Not Used
DSW3
ON
OFF
12345678