Filter
Top Products
Section 5: Printer Configuration
M84Pro Service Manual PN 9001111A Page 5-11
PITCH OFFSET
+ 00mm
The label Pitch is the distance from the leading edge (the edge that comes out
of the printer first) of a label and the leading edge of the next label. The
leading edge position of the label can be adjusted relative to the print head +/-
49 mm in increments of 1mm. Once the position is set, it can be fine adjusted
+/- 3.75 mm using the PITCH potentometer.
1. The cursor will initially be positioned over the Pitch Direction setting. Use
the LINE key to step to the positive (+) or negative (-) selection. A positive
selection moves the leading edge of the label forward (away from the print
head) while a negative selection moves the leading edge of the label back
into the mechanism.
2. Press the FEED key to select the option and advance the cursor to the
Offset selection.
3. Use the CURSOR keys to step the first digit of the counter to the desired
option. The display will increment one step each time the Cursor keys are
pressed. The maximum setting is 5.
4. Press the FEED key to select the option and advance the cursor to the
second digit. Again use the CURSOR keys to step to the desired option.
5. Press the FEED key to select the option and advance to the next display
6. Print a test label after completing the adjustments to ensure they are
correct.
CANCEL PRINT JOB
YES NO
Selecting the YES option will cause all print jobs to be cleared and not
recovered. The default option is NO.
1. Use the Cursor keys to step the cursor to either the YES or NO option.
2. Press the ENTER key to select the option and advance to the next display
CANCEL PRINT JOB
COMPLETED
The printer will beep 3 times and the display will appear for 3 seconds before
returning to the initial On-Line Normal Mode after the print jobs are cleared.
The printer must be taken off-line and the user settings must be re-entered to
change any of the settings.
ADVANCED MODE
An Advanced Mode is provided to make adjustments that require only occasional changes. Since they
affect the basic operation of the printer, the procedure for entering this mode is designed to prevent
someone from accidently changing the settings.
LCD DISPLAY DEFINITION
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ADVANCED MODE Press and hold the LINE key while switching the power switch On. Release
the LINE key when the printer emits one long beep. Press FEED.
DARKNESS RANGE
A B
This setting allows the selection of darkness ranges. Option B is the darker
image of the two. Use the LINE key to move the cursor to the desired option
and press the FEED key to select.
LCD DISPLAY DEFINITION