Filter
Top Products
Section 7: Replacement Procedures
M84Pro Service Manual PN 9001111A Page 7-12
12 Secure each end of platen roller (1) with clamps (3) and screws (2).
13 Insert pulley (5) onto the left spindle and apply inner belt (not shown).
14 Apply outer belt (not shown) to gear (5) and e-clip (4) to left roller spindle.
15 Adjust belt tension as required in accordance with its relative procedure.
16 Reconnect power supply cord, test cycle, and reattach/close all covers.
Figure 7-10, Platen Roller Replacement
FEED ROLLER REPLACEMENT
The feed roller is considered to be a high wear component due to its treading against the print
media. This treading contact will eventually wear grooves into the rubber material and negatively
effect print output.
1 Switch off the printer and disconnect the power supply cord.
2 Open or remove the top, right, and left housing covers.
3 Remove ribbon and media to provide free access to drive roller (1, Figure 7-11).
NOTE: Figures 10-1, 10-2, and 10-3 of the Daigrams & Schematics section
provides guidance on housing cover, media, and ribbon installation.
NOTE: Figures 10-1, 10-2, and 10-3 of the Daigrams & Schematics section
provide guidance on housing cover, media, and ribbon removal.
2
3
6
1
6
7
5
4