Filter
Top Products
Section 5: Printer Configuration
M84Pro Service Manual PN 9001111A Page 5-7
Repeat Print via External Signal (DSW3-8): Allows the applicator or other external device to
reprint the current label in the print buffer.
DEFAULT SETTINGS
All switches are placed in the Off default position for shipping. This will result in the following
operating configuration:
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again changed
by receipt of a command containing a new setting. These settings are stored in non-volatile
memory and are not affected by powering the printer off. The printer may be reset to use the
default software settings by depressing the LINE and FEED keys simultaneously while powering
the printer on. This will result in the following default configuration.
DEFAULT SETTINGS
Communications 8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol: Ready/Busy
Sensor Gap Sensor
Receive Buffer Multi Job
Mode Batch/continuous
Label Sensor Sensor Used
Backfeed Enabled
External Signals Enabled
SOFTWARE DEFAULT SETTINGS
Print Darkness 3
Print Speed 6 Inches Per Second (3 for M84Pro-6)
Print Reference Vertical = 0000, Horizontal = 0000
Print Offset +0
Zero No Slash
Ignore CR/LF Disabled
Character Pitch Proportional
Auto On Line Enabled
Feed on Error Enabled
DSW3-8 SETTING
Off Disabled
On Enabled
DSW3
ON
OFF
12345678